comfast wifi extender

For tasks that need a lot of data transfer, such as online gaming or live video streaming, the finest networking equipment are Comfast WiFi extenders. However, customers have been reporting a wide range of extender-related troubles as of late. One of them is the red light on Comfast extenders.

Has your Comfast WiFi repeater started flashing red, and it’s starting to upset you as well? If you answered “yes” to that question, then, first of all, take it easy! It’s a little technological glitch, not a catastrophic worldwide emergency. We hope this post helps shed some light on the root causes of the red light problem and the steps you may take to get rid of it for good. Read on then!

Reasons Behind Comfast Extender Red Light

  1. Old or faulty software updates
  1. Connection problems
  1. That’s an overlapping connection
  1. Inadequate access to electricity
  1. Dismal WiFi connectivity between devices

The red light on your Comfast extender might be due to any of these problems. Follow the procedures below to try to fix the problem.

Fixed: Comfast WiFi Extender Red Light Issue

  1. Update the Firmware

Updating the firmware on your Comfast extender is the first step in fixing the red light problem. It is well knowledge what occurs when updates are overdue. The technological apparatus either becomes dysfunctional or begins displaying strange behavior. It’s likely that the red light on your Comfast extender is due to incompatible firmware. Fixing the problem requires upgrading the device’s firmware to the most recent version.

You may upgrade your WiFi extender by visiting the default IP, selecting Settings, and then clicking the Firmware Update option. But, you are not supposed to interrupt the firmware update procedure. There are chances that you’ll land into other major issues.

  1. Make the Cable Connections Stable

Technical problems may also be caused by loose cable connections. It is imperative that you again verify the tightness of all your cable connections. Your cable connections should be as tight as your fingers. Otherwise, dealing with the warning light problem has just begun.

  1. Connect Your WiFi Devices Properly

Problems like the one you’re having right now are almost inevitable if the connection between your cable modem and extender is poor. If you’re using WiFi, be sure all of your gadgets are properly connected. You should immediately correct your error of connecting them wirelessly by instead using an Ethernet cable. Otherwise, you might encounter problems while accessing the Comfast repeater setup dashboard.

  1. Check Power Supply

Is your Comfast WiFi extender dying because it isn’t getting enough power from the socket? Probably. Otherwise, you wouldn’t be trapped by the red light dilemma. First, check that your gadget is getting enough power before trying to fix the problem.

It is recommended that you use an alternative wall socket for your extender if you suspect that the one it is now hooked into is malfunctioning.

  1. Reset Your Comfast Extender

If the red light on your Comfast extender still won’t go away after trying the above solutions, it’s time to do a factory reset.

If you’d want to return your extender to its factory settings, follow these steps:

  • The Reset button on most extenders may be found on the bottom of the device.
  • When you do, use something like a pin to gently press it.
  • Keep your finger on the button for a few seconds. Then let go of it gradually.

Once you are done resetting your Comfast WiFi extender, verify whether the red light problem is still present in the photo. If not, then congratulations. However, you need to set up your Comfast repeater from scratch. Your extender’s handbook may help do that. From the Comfast WiFi repeater setup process to firmware update, it encapsulates every single piece of information regarding your Comfast extender.